Categories

Knowledge

Installation and maintenance of grinding machines
Nov 27, 2018

The maintenance of the machine is an extremely important regular work, it should be in close cooperation with the extreme operation and maintenance, etc., should be dedicated personnel to carry out duty inspection.

Machine Maintenance: 

1, bearing bear the full load of the machine, so good lubrication on the bearing life has a great relationship, it directly affects the service life and operating rate of the machine, so the required injection of lubricating oil must be clean, sealing must be good, the main oil injection of the machine (1) rotating bearings (2) roller bearings (3) All Gears (4) Active bearings, sliding plane.

2, the newly installed hoop is prone to loosening must be checked frequently.

3, pay attention to the machine parts of the work is normal.

4, pay attention to check the wear degree of easy wear parts, at any time pay attention to replace the worn parts.

5, put the moving device of the chassis plane, should go out dust and other things to avoid the machine encountered can not break the material when the active bearing can not move on the chassis, so that there is a serious accident.

6, bearing oil temperature rise, should immediately stop to check the reasons to eliminate.

7, rotating gear in the operation of the impact sound should immediately stop to check, and eliminate

Installation test:

1, the equipment should be installed on the basis of horizontal concrete, with foot bolts fixed.

2, installation should pay attention to the host body and horizontal vertical.

3, after installation to check the bolts of all parts are loose and the main warehouse door is fastened, such as please carry out fastening.

4, according to the power of the device to configure the power cord and control switch. 5, inspection completed, air load test, normal test can be produced.


  • QR CODE
  • facebook